Hwmon2/pwm3 is currently setup for automatic speed control. Hwmon2/pwm2 is currently setup for automatic speed control. You want to setup this output for manual control? (n) y It is more efficient and it reacts faster. In general, automatic mode is preferred over manual mode, as Hwmon1/pwm1 is currently setup for automatic speed control. Physically verify that the fans have been to full speed However, it is ** very important ** that you The program will attempt to restore each fan to full speedĪfter testing. We will attempt to briefly stop each fan using the pwm controls. Note that many motherboards do not have pwmĬircuitry installed, even if your sensor chip supports pwm. This program will search your sensors for pulse width modulation (pwm)Ĭontrols, and test each one to see if it controls a fan on # Configuration file generated by pwmconfig, changes will be lost THE ETC/FANCONTROL FILE (AFTER RUNNING PWMCONFIG) Thank you so much for your help and time! Please help me identify my mistakes so that the etc/fancontrol file actually has entries. I tried getting help from Arch-Wiki but there the pwmconfig process is not further explained. I ran $ sudo sensors-detect then sudo pwmconfig (the process of pwmconfig is shown down below) and now wanted to modify the fancotrol file (also copy pasted down below) so that the fans only work at high temperatures, but unfortunatly the does not have any pairs of fans and pwms anywhere, so that it is useless.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |